BLADEZ ION 450 Anleitung zur Fehlerbehebung Seite 1

Product Handbook FOR THE BLADEZ ION 450 ELECTRIC POWER BOARD PLEASE BE SAFE WHEN RIDING . . . ALWAYS WEAR A HELMET AND OBEY ALL

Page 9 RIDING NOTE: If the unit is at the ON position for over 10-15 minutes without moving, Smart Power will shut the scooter OFF. To turn the scoo

Page 10 Batteries The ION 450 comes with 2 12V-10Ah batteries. The batteries come in a pack that is located under the deck. The battery pack has one

Page 11 RECOMMENDED TOOLS To adjust and service the Bladez ION 450 Power Board the following additional tools may be helpful:  Allen Keys: 6mm

Page 12 wheels. The wheels are actually two wheel halves (split rim) bolted together to make it easier to remove and replace the tires and tubes. CAU

Page 13 For regular adjustments: 1. Using a 17mm wrench, loosen the axle bolt on the rear wheel. (FIG. 12) 2. While the axle bolt is loose, using

Page 14 TROUBLESHOOTING GUIDE The following guide will help assist you in identifying and correcting common problems with your ION 450: Symptoms Po

Page 15 Hwww.ebladez.com Bladez, Corp. 20155 Ellipse Foothill Ranch, CA 92610

Page 1 IMPORTANT BATTERY MAINTENANCE and CHARGING INSTRUCTIONS 1. You MUST Charge your scooter completely prior to initial use. (Follow charging in

Page 2 IMPORTANT PLEASE READ THIS BEFORE USING THIS PRODUCT WARNING This product does not conform to Federal Motor Vehicle Standards and is no

Page 3 IF YOU HAVE ANY QUESTIONS OR NEED ASSISTANCE, PLEASE CALL BLADEZ, TOLL FREE AT: (866) EBLADEZ (866) 325-2339 MONDAY thru FRIDAY, 8am

Page 4 TABLE OF CONTENTS HBATTERY MAINTENANCE AND CHARGING INSTRUCTIONS...H1 HGETTING TO KNOW YOUR BLADEZ POWER

Page 5 GETTING TO KNOW YOUR BLADEZ POWER BOARD Before operating your Bladez ION 450 ELECTRIC POWERBOARD, please familiariz

Page 6 BOX CONTENTS Your Bladez ION 450 should come complete with: 1. Bladez ION 450 ELECTRIC POWERBOARD 2. AC Wall Charger 3. 3mm/4mm/5mm Alle

Page 7 4. Insert the bolt with the handlebar clip into the top hole and push through the steering tube. Insert the other bolt into the lower hole an

Page 8 pipe and adjust to your preference and tighten the nut on the underside of the seat. You may now adjust the seat to your preferred height by m