BLADEZ PB-SM806 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 10)

Page 10

GETTING STARTED

YOUR SCOOTER WILL COME CHARGED OUT OF THE BOX BUT YOU MUST

CHARGE YOUR EX 350 FOR 6-8 HOURS EVEN IF THE LIGHT IS GREEN PRIOR TO

FIRST USE!

Unfolding

1. To unfold your EX 350, hold the unit with one hand, while gently pulling up on the

handlebars with the other.

2. Fully extend the handlebars to their upright position until you feel the mechanism lock

into place.

3.You are now ready to ride your Power Board.

Before you Ride

1. The EX 350 is shipped with the Handlebars

unattached.

2. You need to insert the accelerator and

brake levers into the handlebars. To insert,

remove the screws from the handle bar,

then insert the right and left handle and

align the holes. (Fig.1). Then insert the

screws through the holes and tighten the

nuts. (Fig. 2).

*Note: The Accelerator Lever (the one with the

shorter lever) goes on the right, the Brake Lever

goes on the left.

3. Make sure all of the bolts are tightened.

Also make sure to insert the bolts in the

correct way with the nuts on the back side

of the handlebars as in Fig. 2

4. Make sure the tires are inflated to 50 PSI as

tires may lose pressure during shipping. For

information on inflating tires, please refer to

page 10.

* Note: It is not advisable to operate your Power Board on low tire pressure. This will negatively affect

speed, handling and performance.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Keine Kommentare

BLADEZ PB-SM806 Anleitung zur Fehlerbehebung Seite 10